If you would like The CMM Group to prepare a proposal for a dryer or oven for your company, please fill out the form provided and email it to The CMM Group for immediate action.

Company:
Contact:
Contact Title:
Address:
City:
State:
Zip:
Country:
Phone #:
Fax #:
Email:
Your Industry:
My Need is:	Immediate    Future
	Product Specifications
	1. What is the web material?     (paper, foil, polyester, propylene, etc.)
	2. What is the maximum/minimum web weight or the     maximum/minimum web thickness?
	3. What is the size of ream being used in square feet or     square meters?
	4. What is the maximum/minimum web width?
	5. What type of coating will be used?
	6. Is the coverage a dry or wet coating?
	7. Is the measured coverage a dry or wet coating?
	8. What is the maximum/minimum coating being applied?
	9. If the coating coverage is given in thickness, is it     necessary to get the weight of the coating in pounds     per gallon or the amount of coating in gallons per hour?
	10. What is the solvent or combination of solvents being      used in the coating? (toluene, water, MEK, etc.)
	11. If a combination of solvents is used, what are the ratios      or percentages of each?
	12. How many sides of the web are being coated before it      enters the dryer?
	13. What is the speed of the web in FPM?
	14. What is the maximum temperature and unit of measure      that the web can achieve?
	15. What is the temperature and the units of measure of      the web before it enters the dryer?
	16. What is the percentage of moisture contained in the web?      (Example:  Dry notebook paper contains 5% moisture.)
	17. What is the desired moisture level for the web      exiting the dryer?
	18. What is the desired heat source?
	19. What is the web tension? Specify units of measure -      i.e. (PLI).
	20. Standard design is valid to 1,500 feet above sea level.      If the plant site where the dryer will be installed is over      1,500 feet above sea level, state the elevation level.
	21. Are there any special process requirements ie: clean      room Class 1000 or Class 100?
	22. Select the type of motor preferred:      TEFC - Totally Enclosed Fan Cooled High Efficiency                             (standard used)      TEXP -  Explosion Proof for Hazardous Locations      Premium - Premium Efficiency Motors
	23. Please indicate the amount of ductwork you would like      us to quote for each zone preferred:                              Duct Work                    Amount Recirculation:      Makeup Air:           Exhaust:
	24. If the equipment is to be elevated off the floor, do you      require catwalks, railings, stairs, etc?
	25. Would you like us to quote structural supports for the      dryer and/or equipment platform, and if so, how high off      the floor?
	26. Do you require that there be special materials:      i.e. stainless steel, used in the construction of the air      bars, dryer interior, ductwork, etc?
Comments: